7. Unplug the laser/scanner ribbon cable (callout 8) from the laser/scanner and disconnect one inline
connector (callout 9). Then, unwind the front-door microswitch cable from the cable guides and
then remove the microswitch (callout 10) from its housing.
9
10
Figure 5-56 Removing the ECU (5 of 6)
Figure 5-57 Reinstalling the front-door microswitch cable
Reinstallation tip Upon reinstallation, replace the microswitch in its housing and then
route the cable as shown in
Figure 5-57 Reinstalling the front-door microswitch cable
on page 135.
ENWW Engine control unit (ECU) 135
To Next Page
Loading...