Clear jams from the input-tray areas
NOTE To remove media from the tray 1 area, slowly pull the media out of the device. For all
other trays, complete the following procedure.
1. Slide the tray out of the device, and remove any damaged paper from the tray.
2. If the edge of the paper is visible in the feed area, slowly pull the paper down and out of the device.
If the paper is not visible, look in the front door area.
NOTE Do not force the paper if it will not move easily. If the paper is stuck in a tray, try
removing it through the tray above (if applicable) or through the front door area.
220 Chapter 6 Troubleshooting ENWW
To Next Page
Loading...