Page skew
1. Print a few more pages to see if the problem corrects itself.
2. Verify that there are no torn pieces of media inside the device.
3. Make sure that media is loaded correctly and that all adjustments have been made. (See the user
guide.) Make sure that the guides in the tray are not too tight or too loose against the stack.
4. Turn over the stack of paper in the tray. Also, try rotating the stack 180°.
5. Make sure that the type and quality of the media that you are using meet HP specifications.
(See
Media specifications on page 15.)
6. Make sure that the environmental specifications for the device are being met. (See
Operating
environment on page 22.)
7. The registration assembly might be installed incorrectly or damaged. Make sure that the registration
assembly is installed correctly. If necessary, replace the registration assembly (see
Registration
assembly on page 183).
NOTE If copies are skewed, but pages printed from the computer are not skewed, make sure
that the ADF input tray is installed correctly (see
Figure 5-5 Reinstalling the ADF input tray
on page 83). ADF jams and skew can result from incorrect reinstallation.
Curl or wave
1. Turn over the stack of media in the tray. Also, try rotating the stack 180°.
2. Make sure that the type and quality of the media that you are using meet HP specifications.
(See
Media specifications on page 15.)
3. Make sure that the environmental specifications for the device are being met. (See
Operating
environment on page 22.)
256 Chapter 6 Troubleshooting ENWW
To Next Page
Loading...