Parts removal order
Each section contains a list of covers and assemblies that have to be removed before working on the
major assembly that is the subject of the section.
Control panel
Automatic document feeder (ADF)
Transfer roller
Tray 1 pickup roller
Tray 2 pickup roller
Right-side cover
Formatter shield
Disk drive
Formatter
Fax cover
Left-side cover
Back cover
I/O cover
Fuser
Access plate
Oblique-roller assembly
ADF/scanner assembly
Fax accessory
Registration assembly
Stapler
Back cover
I/O cover
Fax rail
Top cover
Fax accessory
Disk drive
Formatter
Stapler power-supply
Front, right cover
Right-side fan
Cartridge door
All covers and the ADF/scanner assembly
Left-side riser
Laser/scanner
E-label reader
Face-down-roller shaft
Left-side fan
Fax accessory
Disk drive
Formatter
Stapler
Stapler power-supply
Right-side fan
ECU
Tray 1 solenoid
Left-side riser
Access plate
Oblique-roller assembly
Left-side fan
High-voltage power supply (HVPS)
Feed-guide assembly
Main motor
Gear assembly
Tray 2 solenoid
Pickup assembly
Tray 1 media-present sensor
Top-of-page sensor
Figure 5-1 Parts removal diagram
ENWW Introduction 79
To Next Page
Loading...