3. Remove the 4 Phillips PM2.5×5.0 screws (1) that secure the display assembly to the device.
NOTE: One screw on the left hinge (2) also secures the display panel cable ground strap.
4. Remove the display assembly.
5. If it is necessary to replace the display bezel, perform the following steps:
a. Remove the display hinge covers (1).
b. Flex the inside edges of the top and bottom (2), and then the left and right sides (3) of the
display bezel until the bezel disengages from the display enclosure.
c. Remove the display bezel (4).
66 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
