System Configuration menu
NOTE: Some of the listed System Configuration options may not be supported by your computer.
Select To do this
Language Change the Computer Setup language.
Boot options
●
Set an f9, f10, and f12 delay when starting up.
●
Enable/disable CD-ROM boot.
●
Enable/disable floppy boot.
●
Enable/disable internal network adapter boot.
●
Enable/disable MultiBoot, which sets a boot order that
can include most boot devices in the system.
●
Set the Express Boot Popup delay in seconds.
●
Set the boot order.
◦
1st boot device: USB CD-ROM
◦
2nd boot device: USB floppy
◦
3rd boot device: USB SuperDisk
◦
4th boot device: Notebook hard drive
◦
5th boot device: USB hard disk
◦
6th boot device: Network controller
Device configurations
●
Swap the functions of the fn key and left ctrl key.
●
Enable/disable USB legacy support. When enabled, USB
legacy support allows the following:
◦
Use of a USB keyboard in Computer Setup even
when a your operating system is not running.
◦
Startup from bootable USB devices, including a hard
drive, diskette drive, or optical drive connected by a
USB port to the computer.
●
Enable/disable BIOS DMA data transfers.
●
Enable/disable fan always on while connected to an AC
outlet.
●
Enable/disable data execution prevention.
●
Enable/disable LAN power saving mode.
●
Enable/disable SATA Native Mode.
●
Enable/disable Dual Core CPU.
●
Enable/disable HDD translation mode.
Built-in device options
●
Enable/disable embedded WLAN Device Radio.
●
Enable/disable embedded Bluetooth Device Radio.
●
Enable/disable Network Interface Controller (NIC)
98 Chapter 11 Computer Setup
To Next Page
Loading...
Need help?
General
