Understand the battery
1 Battery – Supplies power to the printer.
2 Battery release slider – Slides to release the battery.
Charge and use the battery
WARNING! Charge the battery for 4 hours before using the battery for the first
time. Because the battery is normally warm while it is charging, do not charge it in
a briefcase or other confined space as this might cause the battery to overheat.
NOTE: The AC adapter is normally warm to the touch when plugged into an AC
outlet.
NOTE: Bluetooth printing uses more battery power than wired printing. For
information on checking the battery charge level, see
Install and use the battery.
To install the battery
NOTE: You can install the battery with the printer turned on or off.
1. Slide the battery into the battery slot at an angle, until the contacts on the battery
are flush with the contacts in the battery slot. The battery contact cover slides open.
2. Push the battery into the battery slot until the battery clicks into place.
Install and use the battery
19
To Next Page
Loading...
