HP Officejet 6000 - Page 5

Set up Wireless (802.11) communication 5
English
Step 2: Install software for your HP Officejet/Officejet Pro device
You must run the installation program from the Starter CD. The installation program installs the software and creates a
wireless connection.
Windows
IMPORTANT: Do not connect the USB wireless setup
cable until prompted by the software.
1. Save any open documents. Close any applications
that are running on your computer.
2. Place the Starter CD into the computer.
3. On the CD menu, click Install Network/Wireless
Device, and then follow the onscreen instructions.
NOTE: If the firewall software on your computer
displays any messages during the installation, select the
“always permit/allow“ option in the messages.
Selecting this option allows the software to install
successfully on your computer.
4. The installation program attempts to find the printer.
After it finishes the search, click Next.
5. When prompted, temporarily connect the
USB wireless setup cable.
6. Follow the onscreen instructions to complete the
installation.
7. Disconnect the USB wireless setup cable when
prompted.
Mac OS
1. Connect a USB wireless setup cable to the port on
the back of the HP device and then to any USB port
on the computer.
2. Place the Starter CD into the computer.
3. Double-click the HP Installer icon on the Starter CD,
and then follow the onscreen instructions.
4. Disconnect the USB wireless setup cable when
prompted.