9
English
9
Set up wireless (802.11) communication
Step 2: Test the wireless connection
To test the wireless connection and make sure it is
working properly, complete the following steps:
1. Make sure the printer is turned on and paper is
loaded in the tray.
2. Press and hold the
(Resume) button, and then
press the
(Wireless) button.
The printer prints a report with the results of the test. If
the test fails, review the report for information on how
to x the problem and rerun the test.
Change the connection type
If you have installed the HP software, you can change
to a different connection any time you want.
Note: If you are changing from a wired (Ethernet)
to a wireless connection, disconnect the Ethernet
cable. Connecting an Ethernet cable turns off the
printer’s wireless capabilities. You might be
prompted to temporarily connect a USB cable
during the setup process.
Follow the instructions for your operating system.
Mac OS X
1. On the printer control panel, press and hold
the
(Wireless) button and the (Cancel)
button for three seconds.
2. Open HP Utility. (HP Utility is located in the
Hewlett-Packard folder in the Applications
folder at the top level of the hard disk.)
3. Click Applications on the toolbar.
4. Double-click HP Setup Assistant, and then
follow the onscreen instructions.
Windows
1. On the printer control panel, press and hold
the
(Wireless) button and the (Cancel)
button for three seconds.
2. On the computer desktop, click Start, select
Programs or All Programs, click HP, select
your printer name, and then click Printer
Setup & Software.
3. Follow the display instructions to complete
the setup.
For additional troubleshooting information, see
“Wireless (802.11) setup problems” on page 11.
To Next Page
Loading...
