Use the Embedded Web server (EWS)22
To open the EWS
1.  Obtain the IP address for the printer. The IP address is 
shown on the Network Conguration Page.
a.  Load paper in the tray.
b.  Touch the right arrow  , touch Setup, touch 
Network Conguration Page, and then touch 
Reports.
2.  In a supported Web browser on your computer, type the 
IP address or hostname that has been assigned to the 
device.
For example, if the IP address is 123.123.123.123, type the 
following address into the Web browser: 
http://123.123.123.123 
 Tip: After opening the EWS, you can bookmark it so 
that you can return to it quickly.
5. Use the Embedded Web server (EWS)
When the printer is connected to a network, you can use the 
“embedded Web server” (“EWS”) to view status information 
and congure network settings from your computer web 
browser. No special software needs to be installed or 
congured on your computer.
 Note: You can open and use the EWS without being 
connected to the Internet, though some features will not 
be available.
For more information about the EWS, see the user guide 
(which is available on your computer after you install the 
software).