Use the Embedded Web server (EWS)22
To open the EWS
1. Obtain the IP address for the printer. The IP address is
shown on the Network Conguration Page.
a. Load paper in the tray.
b. Touch the right arrow , touch Setup, touch
Network Conguration Page, and then touch
Reports.
2. In a supported Web browser on your computer, type
the IP address or hostname that has been assigned to
the device.
For example, if the IP address is 123.123.123.123, type the
following address into the Web browser:
http://123.123.123.123
Tip: After opening the EWS, you can bookmark it so
that you can return to it quickly.
5. Use the Embedded Web server (EWS)
When the printer is connected to a network, you can
use the “embedded Web server” (“EWS”) to view status
information and congure network settings from your
computer web browser. No special software needs to be
installed or congured on your computer.
Note: You can open and use the EWS without being
connected to the Internet, though some features will
not be available.
For more information about the EWS, see the user guide
(which is available on your computer after you install the
software).
To Next Page
Loading...
