Set up and use fax 7
English
Connecting to a DSL/ADSL line
If you subscribe to a DSL/ADSL service, follow these steps to connect the fax.
1
32
1. Connect the DSL/ADSL lter and telephone cord provided by your
DSL/ADSL service provider between the telephone wall jack and the
DSL/ADSL lter.
2. Connect the telephone cord provided with the printer between the
DSL/ADSL lter and the 1-Line port on the printer.
1 Telephone wall jack
2 DSL/ADSL lter and telephone cord (provided by your DSL/ADSL service provider)
3 Telephone cord provided in the box with the printer, connected to the 1-LINE port on the printer
Connecting additional equipment
Remove the white plug from the port labeled 2-EXT on the back of the printer, and then connect a phone to this
port.
If you are connecting additional equipment, such as a dial-up computer modem or a telephone, you will
need to purchase a parallel splitter. A parallel splitter has one RJ-11 port on the front and two RJ-11 ports
on the back. Do not use a 2–line phone splitter, a serial splitter, or a parallel splitter which has two RJ-11
ports on the front and a plug on the back.
Note: If you subscribe to a DSL/ADSL service, connect to the DSL/ADSL lter to the parallel splitter, and then use the HP-
provided telephone cord to connect the other end of the lter to the 1-Line port on the printer. Remove the white plug from
the port labeled 2-EXT on the back of the printer, and then connect a telephone set or telephone answering machine to
the 2-EXT port. Next, connect the second port of the parallel splitter to the DSL/ADSL modem which is connecting to the
computer.
1
5
4
2
7
3
6
1 Telephone wall jack
2 Parallel Splitter
3 DSL/ADSL lter (available from your DSL/ADSL service
provider)
4 Phone cord provided with printer
5 DSL/ADSL Modem
6 Computer
7 Telephone
To Next Page
Loading...
