5. Lower the output tray.
6. Pull out the tray extender.
Load cards and photo paper
To load cards and photo paper
Use these instructions to load photo paper.
1. Lift the output tray.
2. Slide out the paper width guide in the input tray as far as possible.
NOTE: If you are loading larger sized media, pull up the front edge of the input
tray to extend it.
3. Insert the media print-side down in the tray. Make sure the stack of media is inserted
as far inside the printer as possible and does not exceed the line marking in the tray.
If the photo paper has a tab along one edge, make sure the tab is pointing towards
the front of the printer.
NOTE: Do not load paper while the printer is printing.
4. Slide the media guides in the tray until they touch the edge of the stack of media.
5. Lower the output tray.
6. Pull out the tray extender.
Load media 23
To Next Page
Loading...