Limitations to rules, templates, and services
When creating firewall rules, note the following limitations to rules, templates, and services.
Item Limit
Maximum number of rules. 10 (one default rule)
Maximum number of Address Templates. 12
Maximum number of user-defined address
templates.
5
Maximum number of services you can add to
a user-defined service template.
NOTE: The predefined All Services template
is not subject to this limitation and includes all
services supported by the print server.
40
Maximum number of services you can add to
the policy.
For a given rule, only one address template
and one service template can be added.
40
Maximum number of service templates in the
policy.
10
Maximum number of user-defined custom
service templates.
5
Reset network settings
To reset the administrator password and network settings, press and hold (Wireless button)
and
(Cancel button) for three seconds.
NOTE: Print the network configuration page and verify that the network settings have been
reset. For more information, see
Understand the network configuration page.
NOTE: Resetting the printer’s network settings also resets the printer’s firewall settings. For
more information about configuring the printer’s firewall settings, see
Configure the printer’s
firewall settings.
Set up the printer for wireless communication
You may set up the printer for wireless communication.
This section contains the following topics:
•
Before you begin
•
Set up the printer on your wireless network
•
Set up the printer using the HP printer software (Recommended)
•
Set up the printer using WiFi Protected Setup (WPS)
•
Set up the printer using the embedded web server (EWS)
•
Change the connection type
•
Test the wireless connection
•
Guidelines for ensuring wireless network security
•
Guidelines for reducing interference on a wireless network
NOTE: If you encounter problems connecting the printer, see Solve wireless problems
Set up the printer for wireless communication 119
To Next Page
Loading...
