5. Make sure the latch handle is raised, and then reinsert the printhead.
6. Carefully lower the latch handle.
NOTE: Make sure you lower the latch handle before reinserting the ink
cartridges. Leaving the latch handle raised can result in incorrectly seated ink
cartridges and problems printing. The latch must remain down in order to
correctly install the ink cartridges.
7. Close the ink-cartridge access door and the top cover.
Clear jams
Occasionally, media becomes jammed during a job. Try the following remedies before
you attempt to clear the jam.
• Make sure that you are printing with media that meets specifications. For more
information, see
Media specifications.
• Make sure that you are printing with media that is not wrinkled, folded, or damaged.
• Make sure that the printer is clean. For more information, see
Maintain the printer.
• Make sure that the trays are loaded correctly and are not too full. For more
information, see
Load media.
This section contains the following topics:
•
Clear paper jams
•
Avoid paper jams
Clear paper jams
If the paper was loaded in the input tray, you might need to clear the paper jam from
the duplexer.
Clear jams 77
To Next Page
Loading...
