Output bin
▲
Lift and remove the output bin.
Figure 1-16 Remove the output bin
Output bin flap
1. Remove the output bin. See Output bin on page 13.
2. Flex the middle of the output bin flap, and then remove the flap by pulling the rear pin (callout 1)
away from the product first.
Figure 1-17 Remove the output bin flap
1
Reinstallation tip With the flap in the open position, insert the front pin into the product first,
and then flex or bend the flap to install the rear pin.
ENWW
Removal and replacement procedures
13
To Next Page
Loading...
