9. Unthread the feed drive motor cable from the fan assembly housing.
Figure 1-55 Remove the aerosol fan (8 of 12)
10. Push the sensor carriage ferrite (callout 1) out through the side of the snap using a small
screwdriver. Leave the sensor carriage motor plugged in. During re-assembly, the sensor
carriage ferrite can pushed to the left back through the snaps as shown in
Figure 1-56 Remove
the aerosol fan (9 of 12) on page 40.
Figure 1-56 Remove the aerosol fan (9 of 12)
1
40 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...
