11. Remove three screws (callout 1) mounting the housing to the sheet metal.
Figure 1-57 Remove the aerosol fan (10 of 12)
1
12. Pull out the fan assembly.
Figure 1-58 Remove the aerosol fan (11 of 12)
CAUTION: Avoid placing the assembly on any surface with the duct opening and gasket ring in
contact with the surface. Doing so will leave an ink ring on the surface. Additionally, avoid touching
the duct opening and gasket ring.
Reinstallation tip Align the black lines (callout 1) on the flex cables with the indicators on the fan
assembly housing.
ENWW
Removal and replacement procedures
41
To Next Page
Loading...
