●
Printbar lift knob–used for lifting and holding the printbar.
NOTE: Use a ¼” nut driver (6.4mm) to raise the printbar.
Figure 1-2 OfficeJet Pro X special tools–printbar lift knob
●
Service sled advance tool–used to remove and reinstall the service sled.
NOTE: Use a ¼” nut driver (6.4mm) to remove or install the service sled
Figure 1-3 OfficeJet Pro X special tools–service sled advance tool
●
Printbar dolly–used to support the printbar during removal and installation.
Figure 1-4 OfficeJet Pro X special tools–printbar dolly
4 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...
