Table 3-1 Computer Setup—Main (continued)
1st Drive
2nd Drive
For each, allows you to set:
●
Port Configuration - enable/disable (default is enabled)
Capacity (Size - HDD only; view only)
Transfer mode (view only)
●
Smart Support - run HDD self-test for selected channel:
◦
SMART Status Check
◦
SMART Short Self-Test
◦
SMART Extended Self-Test
System Information (view only)
●
Installed Memory
●
Memory Bank 1
●
Memory Bank 2
●
BIOS Revision
●
Core Version
Computer Setup (F10) Utilities
9
To Next Page
Loading...
