Pickup/feed/delivery system
The pickup/feed/delivery system consists of several types of feed rollers and sensors. The dc
controller uses two motors and two solenoids to drive the rollers. Three media-detection sensors
detect media as it passes through the printer. If media does not reach or pass each sensor within a
specified time period, the dc controller determines that a jam has occurred and alerts the formatter.
The following components are identified in
Figure 5-6 Pickup/feed/delivery system on page 78:
●
M1, main motor
●
SL1, tray 2 pickup solenoid
●
SL2, tray 1 pickup solenoid
●
SL3, duplex solenoid (HP LJ P2015d, P2015dn, and P2015x only)
●
PS911, width-detection sensor
●
PS912, top-of-page sensor
●
PS913, width-detection sensor
●
PS914, tray 2 media sensor
●
PS915, fuser delivery sensor
●
PS915, duplex sensor (HP LJ P2015d, P2015dn, and P2015x only)
ENWW Pickup/feed/delivery system 77
To Next Page
Loading...