Access plate
1. Remove the following components:
●
Back cover (see
Back cover on page 72)
●
I/O cover (see
I/O cover on page 72)
●
Duplexer inlet guide (see
Figure 5-16 Removing the fuser (1 of 3) on page 83)
2. At the front of the device, push the green button on the top, right front of the tray 2 opening to
release the access plate.
Figure 5-29 Removing the access plate (1 of 2)
3. At the back of the device, press one tab (callout 1) to release the access plate, and then lower the
access plate until the other side slides off of the other tab (callout 2).
1
2
Figure 5-30 Removing the access plate (2 of 2)
4. Slide the pan out of the device.
96 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...