Tray 2 pickup roller
NOTE Also follow these instructions to remove any optional-tray pickup rollers.
1. Tip the device over on its rear side, with the bottom of the device facing you.
2. Rotate the bushings (callout 1) on each side of the roller downward.
1
Figure 5-58 Removing the tray 2 pickup roller (1 of 2)
3. Remove the left-side bushing by sliding the bushing to the left.
4. Slide the roller and shaft toward the left until they clear the hole in the right-side bushing, and then
lift the right end of the shaft.
ENWW Tray 2 pickup roller 125
To Next Page
Loading...