Control panel
1. Remove the following components:
●
Right-side cover (see
Right-side cover on page 69)
●
Top, right cover (see
Top, right cover on page 73)
●
Front, right cover (see
Front, right cover on page 75)
2. Remove the grounding wire over the fan assembly (callout 1), disconnect one cable (callout 2) on
the formatter, and then remove one grounding screw (callout 3).
1
2
3
Figure 5-11 Removing the control panel
3. Lift the control panel off of the device.
Reinstallation tip To reinstall the control panel correctly, use the locator pin (callout 4) and
place the sheet metal front of the control panel assembly (callout 5) in front of the device chassis.
78 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...