CAUTION: Support the display assembly when removing the following screws. Failure to support
the display assembly can result in damage to the display assembly and other computer components.
1. Remove the four Phillips screws from the display hinges (1) and lift the display assembly (2).
2. If it is necessary to replace the webcam/microphone module:
a. Detach and release the webcam/microphone module as far as the webcam/microphone
module cable allows. (The webcam/microphone module is attached to the back cover with
double-sided tape.)
b. Disconnect the webcam/microphone cable (1) from the webcam/microphone module.
72 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
