Filename: sb38028.doc Title: HP-Print2k.dot
Template: HP-Print2K_vertical.dot Author: jiml Last Saved By: kimt
Revision #: 23 Page: 12 of 20 Printed: 01/10/03 10:48 AM
Regulatory and Safety Information
Warning: The HP Pavilion is heavy; be sure to use
ergonomically correct lifting procedures when moving
the computer.
Warning: Electrostatic discharge (ESD) can damage disk
drives, add-in cards, and other components. If an ESD
station is not available, wear a wrist strap attached to a
metal part of the computer. Place cards on a conductive
foam pad or inside the conductive wrapper they came in;
do not place the cards on top of the wrapper.
Warning: Do not operate the system with the cover
removed. Always replace the cover before turning on
the system.
Warning: Please read the “Additional Safety Information”
located later in this document before installing and
connecting your system to the electrical power system.
Warning: Using the wrong type of memory module could
damage the system.
Warning: Do not pull the memory module out of the socket.
Use the retaining clips to eject the module.
Warning: Do not overload the system by installing add-in
cards that draw excessive current. The system is designed
to provide 2 amps (average) of +5 V power for each
board/card in the computer. The total +5 V current draw in
a fully loaded system (one with all add-in card slots filled)
must not exceed the total number of slots multiplied by
2 amps.
Warning: Be careful of the sharp edges on the expansion
slot cover.
Warning: There is danger of an explosion if the battery
is incorrectly replaced. Replace only with the same, or
equivalent, type of battery. Discard used batteries according
to the manufacturer’s instructions.
To Next Page
Loading...
Need help?
General