Filename: sa37020K.doc Title: HP-Print2k.dot
Template: HP-Print2K_vertical.dot Author: kimt Last Saved By: JimL
Revision #: 56 Page: 10 of 18 Printed: 10/15/02 11:54 AM
Regulatory and Safety Information
Warning: The HP Pavilion is heavy; be sure to use
ergonomically correct lifting procedures when moving
the computer.
Warning: Electrostatic discharge (ESD) can damage disk
drives, add-in cards and other components. If an ESD station
is not available, wear a wrist strap attached to a metal part
of the computer. Place cards on a conductive foam pad or
inside the conductive wrapper they came in; do not place
the cards on top of the wrapper.
Warning: Do not operate the system with the cover removed.
Always replace the cover before turning on the system.
Warning: Please read the “Additional Safety Information”
located later in this document before installing and
connecting your system to the electrical power system.
Warning: Using the wrong type of memory module could
damage the system.
Warning: Do not pull the memory module out of the socket.
Use the retaining clips to eject the module.
Warning: Do not overload the system by installing add-in
cards that draw excessive current. The system is designed
to provide 2 amps (average) of +5 V power for each
board/card in the computer. The total +5 V current draw
in a fully loaded system (one with all add-in card slots
filled) must not exceed the total number of slots multiplied
by 2 amps.
Warning: Be careful of the sharp edges on the expansion
slot cover.
Warning: There is danger of explosion if the battery is
incorrectly replaced. Replace only with the same, or
equivalent, type of battery. Discard used batteries according
to the manufacturer’s instructions.
To Next Page
Loading...
Need help?
General
