94
HP Pavilion home PC
Filename: sb3usqs.doc Title: HP-Print2k.dot
Template: HP-Print2K.dot Author: JimL Last Saved By: kimt
Revision #: 159 Page: 94 of 134 Printed: 01/14/03 09:36 AM
7 Press the down arrow key to select Boot Device
Priority, and then press Enter on the keyboard.
8 Change the first boot device to CD-ROM
using one of these methods:
■
Press the down arrow key to select the
CD-ROM item. Press the + (plus) key to
move the CD-ROM item up until it is the
first item in the list.
Or
■
Press the down arrow key to highlight the
First Boot Device selection. Press the + (plus)
key until CD-ROM is the selection.
When installation is complete, you’ll return the
BIOS to the original setting.
9 Press the Eject button on the top CD-ROM
drive, and wait for the tray to open. Insert
Recovery CD #1 and close the tray.
10 Press the F10 key to save the changes, and
exit BIOS.
11 With Yes selected, press Enter.
12 The PC starts the recovery; wait for the
onscreen instructions to display, and then
follow those instructions.
■
For standard recovery, press R, and then
press R again. Click Next to proceed
with the non-destructive system recovery.
Click Yes to start the recovery. Insert the
remaining CDs when directed.
Or
■
For full system recovery, press R, and then
press F. Click Yes to perform a full system
recovery. Insert the remaining CDs when
directed.
Or
■
If your PC hard disk drive is blank or
corrupted, press R to perform a full system
recovery. Insert the remaining CDs when
directed.
To Next Page
Loading...
Need help?
General