6. Remove the two Phillips PM2.0×3.0 screws (1) that secure the optical drive bracket to the optical
drive.
7. Remove the optical drive bracket (2).
8. If it is necessary to remove the drive bezel, insert the end of a paper clip into the release access
hole (1) in the optical drive bezel. Press in gently until the tray is released.
9. Firmly pull outward on the open tray (2) until the drive slides out.
10. Press the bezel release button (1), lift the bezel at an angle (2), and remove the bezel (3).
56 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
