Power button board
Description Spare part number
Power button board (includes cable) 608226-001
Before removing the power button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 41).
5. Remove the following components:
a. Hard drive (see
Hard drive on page 53)
b. Optical drive (see
Optical drive on page 55)
c. Keyboard (see
Keyboard on page 57)
d. Top cover (see
Top cover on page 59)
Reverse this procedure to install the power button board.
Remove the power button board:
1. Turn the top cover upside down with the rear edge toward you.
2. Remove the two Phillips PM2.0×3.0 screws (1) that secure the power button board to the top
cover.
64 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
Need help?
General