d. Top cover (see Top cover on page 59)
e. USB board (see
USB board on page 71)
Remove the power connector cable:
1. Turn the computer upright with the right side toward you.
2. Disconnect the power connector cable (1) from the system board.
3. Remove the two Phillips PM2.5×5.0 screws (2) that secure the power connector cable to the
base enclosure.
4. Lift the bracket from the connector (3).
5. Remove the power connector (4) from the base enclosure.
Reverse this procedure to install the power connector cable.
Component replacement procedures
73
To Next Page
Loading...
