7. To remove the display/webcam cable, remove the cable from the clips built into the display enclosure
(2), and then remove the cable from the display enclosure (3).
The display cable is available using spare part number 809342-001 for TOP (Touch On Panel) displays
and 811222-001 for touch displays.
8. If replacing the display enclosure, be sure that the subcomponents (including the webcam/microphone
module, the antenna receivers, and all associated cables and hardware) are transferred to the new
enclosure.
Reverse this procedure to reassemble and install the display assembly.
86 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
