4 Modem Command Guidelines
Modem Command Guidelines
Setting the Result Code Format
A result code is the response of the modem to a command. It may
be issued in either of two formats: words (the long form, also
known as verbose) or numeric characters (the short form,
represented by digits).
The result code format is set using the
Vn command:
■ Use V1 for words (default).
■ Use V0 for numeric characters.
Setting Local Character Echo
Local echo is a process that transmits received data back to the
sending station and allows you to see what data was received.
If your typing is not displayed on the screen, local echo is
turned off.
Local echo preferences are set using the
En command:
■ Use EO for no local echo.
■ Use E1 to enable local echo.
316740-002.book Page 4 Thursday, May 1, 2003 1:40 PM
To Next Page
Loading...
