Removal and Replacement Procedures
Maintenance and Service Guide 5–5
4. Remove the hard drive by following these steps:
a. Turn the notebook upside down with the rear panel
facing you.
b. Loosen the four PM2.5×4.0 screws 1 that secure the hard
drive cover to the notebook.
c. Lift the cover straight up 2 to remove it from the
notebook.
✎
The hard drive cover is included in the Miscellaneous Plastics
Kit, spare part number 344852-001.
Removing the Hard Drive Cover
Spare Part Number Information
Hard drives
80-GB (5400-rpm)
80-GB (4200-rpm)
60-GB (5400-rpm)
60-GB (4200-rpm)
40-GB (4200-rpm)
344858-001
344856-001
344857-001
344855-001
344854-001
333621-001.book Page 5 Wednesday, September 17, 2003 12:24 PM
To Next Page
Loading...
