Card is not fully inserted
Solution: Turn the memory card so that the label faces up and the contacts are
facing the product, and then push the card forward into the appropriate slot until the
Photo light turns on.
After the memory card has been inserted properly, the Photo light will blink for a few
seconds, and then remain lit.
Cause: You had not fully inserted the memory card.
Paper messages
The following is a list of paper-related error messages:
•
Paper upside down
•
Paper orientation error
•
Ink is drying
Paper upside down
Solution: Load paper in the input tray print side down.
Cause: Paper in the input tray was upside down.
Paper orientation error
Solution: Insert paper into the input tray with the short edge forward and the print
side down. Slide the paper forward until it stops.
Cause: Paper in the input tray was in landscape orientation.
Ink is drying
Solution: Leave the sheet in the output tray until the message disappears. If it is
necessary to remove the printed sheet before the message disappears, carefully hold
the printed sheet on the underside or the edges, and place it on a flat surface to dry.
Cause: Transparencies and some other media require a drying time that is longer
than normal.
Ink cartridge and printhead messages
The following is a list of printhead and ink cartridge error messages:
•
Cartridges in wrong slot
•
General printer error
•
Incompatible ink cartridges
•
Incompatible printhead
•
Ink alert
•
Ink cartridge problem
•
Ink service capacity warning
Chapter 12
100 Solve a problem
Solve a problem
To Next Page
Loading...