5. With the keyboard toward you, press down on the keyboard while sliding the keyboard toward
the palm rest releasing it from the retention clips.
6. Lift the top of the keyboard at an angle, and then pull the keyboard up to remove it from the palm
rest.
NOTE: Only pull the keyboard up enough to release it from the computer and flip it over onto
the palm rest. The keyboard is connected to the system board via a ribbon cable and a zero
insertion force (ZIF) connector.
7. Release the ZIF connector (1) by lifting the latch.
38 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
