3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 35).
5. Remove the following components:
a. Service door (see
Service door on page 43).
b. Keyboard (see
Keyboard on page 37)
c. Hard drive (see
Hard drive on page 40)
Remove the top cover:
1. Position the computer upside-down with the front toward you.
2. Remove the following screw covers from atop the screws on the bottom of the computer:
(1) 2 rear rubber screw covers
(2) 2 middle rubber screw covers
(3) 2 front rubber screw covers
NOTE: Rubber screw covers are available in the Rubber/Plastics Kit, spare part number
727762-001.
Component replacement procedures
51
To Next Page
Loading...
