Heat sink
All heat sink spare part kits include replacement thermal material.
Description Spare part number
Heat sink L01052-001
Before removing the heat sink, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Place the computer in “Battery Safe mode” (Battery Safe mode on page 32).
3. Disconnect all external devices connected to the computer.
4. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5. Remove the following components:
a. Service doors (Service doors on page 33).
b. Hard drive (Hard drive on page 41)
c. Keyboard (Keyboard on page 44)
d. Top cover (Top cover on page 48)
e. Card reader board (Card reader board on page 59)
f. Battery (Battery on page 65)
g. System board (System board on page 68)
Remove the heat sink:
1. Position the system board upside-down.
2. In the order indicated on the heat sink, loosen the 4 captive Phillips screws (1) that secure the heat sink
to the system board.
Component replacement procedures 71
To Next Page
Loading...
