e. Palm rest (see Palm rest on page 71)
f. Hard drive (see
Hard drive on page 73)
g. Display assembly (see
Display assembly on page 90)
h. Top cover (see
Top cover on page 98)
i. System board (see
System board on page 102)
Remove the USB connector assembly:
1. Position the computer right-side up with the right side toward you.
2. Release the USB connector board cable from the base enclosure clips and routing channel (1).
3. Remove the USB connector assembly (2) from the base enclosure.
Reverse this procedure to install the USB connector assembly.
Component replacement procedures 105
To Next Page
Loading...
