NOTE: For installation, note that the cable routes under the camera module before it connects to
the module.
5. To remove the remainder of the display subcomponents, you must remove the display assembly from
the computer. To remove the display assembly, disconnect the antenna cables from the WLAN module
(1).
6. Remove the cables from the clips around the fan (2), and the disconnect the display cable (3).
7. Disconnect the antenna cables from the WWAN module (4).
8. Remove the cables from the clips (5).
9. Disconnect the WWAN cable from the system board (6).
10. Remove the four Phillips M2.5 × 4.0 screws (1) that secure the display assembly to the computer.
11. Rotate the display to open the hinges (2).
54 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
