EL-MF877-00 Page 2
Template Revision C
Last revalidation date 09-May-2018
HPI instructions for this template are available at EL-MF877-01
Item Description Notes
items
included in
already listed as a separate item above)
Components and parts containing toner and ink,
including liquids, semi-liquids (gel/paste) and toner
Include the cartridges, print heads, tubes, vent
chambers, and service stations. NA
Components and waste containing asbestos
Components, parts and materials containing refractory
ceramic fibers
Components, parts and materials containing
radioactive substances
List the type and size of the tools that would typically be used to disassemble the product to a point where components and
materials requiring selective treatment can be removed.
Tool Size (if
applicable)
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment
including the required steps to remove the external enclosure:
1. Use screwdriver to release base cover #1 screw 5PCS, and disassemble base cover from hinge side
2. Unplug battery cable and use screwdriver to release battery screw 6 PCS and release Battery.
3. Use screwdriver to release heat sink and fan #1 screw 7 PCS, release fan cable and remove it
4. Use screwdriver to release cable holder frame #1 screw 3 PCS
5. Use screwdriver to release daughter board #1 screw 3 PCS
6. Use screwdriver to release man board, daughter board, and cable holder frame #1 screw 4 PCS
7. Set Hinge UP to 150 degree and release hinge up
To Next Page
Loading...
