Computer Setup
Maintenance and Service Guide 5–11
System Configuration menu
✎
Some of the listed System Configuration options may not be supported by your computer.
Select To do this
Language Change the Computer Setup language.
Boot Options ■ Set a Startup Menu delay (in seconds).
■ Enable/disable MultiBoot (enabled by default).
■ Set the Express Boot Popup delay in seconds.
■ Enable/disable Custom Logo (disabled by default).
■ Enable/disable Display Diagnostic URL (enabled
by default).
■ Enable/disable CD-ROM boot (disabled by default).
■ Enable/disable SD Card boot (enabled by default).
■ Enable/disable floppy boot (enabled by default).
■ Enable/disable PXE Internal NIC boot (enabled by default).
■ Enable/Disable Unified Extensible Firmware Interface
(UEFI) Boot Mode (disabled by default).
■ Set the Legacy Boot Order.
Device Configurations ■ Enable/disable USB legacy support (enabled by default).
When enabled, USB legacy support allows the following:
❐ Use of a USB keyboard in Computer Setup even when a
Windows operating system is not running
❐ Startup from bootable USB devices, including a hard
drive, diskette drive, or optical drive connected by a USB
port to the computer
■ Select a parallel port mode: ECP (Enhanced Capabilities
Port), standard, bidirectional, or EPP (Enhanced
Parallel Port).
■ Enable/disable fan always on while connected to an
AC outlet (disabled by default).
■ Enable/disable Data Execution Prevention (select
models only). When enabled, the processor can disable
some virus code execution, which helps to improve
computer security (disabled by default).
■ SATA (Serial Advanced Technology Attachment)
device mode. The following options are available:
❐ AHCI (Advanced Host Controller Interface)
❐ IDE (Integrated Drive Electronics)
❐ RAID (select models only)
✎
Availability of these options varies by computer model.
■ Enable/disable secondary battery fast charge (enabled
by default).
■ Enable/disable HP QuickLook (enabled by default).
■ Enable/disable Preboot Authentication on HP QuickLook
Boot (enabled by default).
■ Enable/disable HP QuickWeb (enabled by default).
(Continued)
To Next Page
Loading...
