1
HP ProCurve 1410-24G Switch Quick Setup Guide
For more detailed information to set up your switch, view or download the Installation and Getting Started Guide for your
switch at www.hp.com/go/procurve/manuals.
1. Unpack and check included parts. ■ Documentation kit
•Read Me First
• Quick Setup Guide
• Safety and Regulatory information
• Software License Agreement and Hardware Warranty
in
formation
■ Switch
■ Accessory kit (installation hardware)
■ AC power cord
2. Prepare for installation. To avoid personal injury or product damage, review the “Safety Precautions” on
page 3.
3. Connect power and verify that the switch power LED turns on. The switch does not contain a power switch. It is
turned on by connecting power through the AC power cord.
4. Install the Switch Hardware. Turn off the switch before installing the switch hardware.
Table or Desktop: At
tach the four self-adhesive pads
(included in the accessory kit) to the bottom corners of
the switch.
© Copyright 2010 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without
notice.
Printed in China
February 2010
5998-0335
*5998-0335*
QSG-1410-24G-Feb2010.fm Page 1 Thursday, February 11, 2010 3:21 PM
To Next Page
Need help?
General
