Need help?Do you have a question about the HP MSR Router Series and is the answer not in the manual?
General| Product Series | MSR |
|---|---|
| Category | Network Router |
| IPv6 Support | Yes |
| WAN Interfaces | Varies by model (e.g., Gigabit Ethernet, Serial, T1/E1) |
| LAN Interfaces | Varies by model (e.g., Fast Ethernet, Gigabit Ethernet) |
| VPN Support | Yes (IPSec, L2TP, GRE) |
| QoS Support | Yes (Priority queuing, traffic shaping) |
| Redundancy | Varies by model (e.g., VRRP, dual power supplies) |
| Management | CLI, Web GUI, SNMP |
| Firewall | Yes (Stateful firewall, NAT) |
Details on supported PPP authentication methods: PAP, CHAP, MS-CHAP, and MS-CHAP-V2.
Tasks for configuring PPP, including encapsulation, authentication, negotiation, and compression.
Tasks for configuring Multilink PPP (MP) using VT or MP-group interfaces.
Practical examples for configuring PPP and MP, including authentication and IP address negotiation.
Configuration tasks for setting up the PPPoE server.
Configuration tasks for setting up the PPPoE client.
Practical examples for configuring PPPoE server and client scenarios.
Basic L2TP capability configuration, including enabling L2TP and creating L2TP groups.
Tasks for configuring an LAC to initiate tunneling requests and specify LNS IP addresses.
Tasks for configuring an LNS to accept tunneling requests and manage VA interfaces.
Practical examples for configuring L2TP tunnels (NAS, client, LAC-auto-initiated).
Steps to enable HDLC encapsulation on an interface.
Steps to configure an HDLC link bundle interface.
Procedure for assigning interfaces to an HDLC link bundle.
Procedure to set the ISDN switch type on an interface.
Procedure to configure the ISDN interface as user-side or network-side.
Procedure to configure ATM interfaces.
Procedure to configure a Permanent Virtual Circuit (PVC).
Procedure to enable PVC/PVC-group to carry PPP and configure PPPoA mapping.
Procedure to enable PVC/PVC-group to carry PPPoE and configure PPPoEoA mapping.
To Next Page
