HP MSR Router Series User Manual

5
Command and hardware compatibility
Commands and descriptions for centralized devices apply to the following routers:
• MSR1002-4/1003-8S.
• MSR2003.
• MSR2004-24/2004-48.
• MSR3012/3024/3044/3064.
Commands and descriptions for distributed devices apply to MSR4060 and MSR4080 routers.
Configuring PPP
PPP configuration task list
Tasks at a
g
lance
(Required.) Enabling PPP encapsulation on an interface
(Optional.) Configuring PPP authentication
(Optional.) Configuring the polling feature
(Optional.) Configuring PPP negotiation
(Optional.) Enabling IP header compression
(Optional.) Enabling PPP link quality monitoring
(Optional.) Enabling PPP accounting
(Optional.) Configuring the nas-port-type attribute
Enabling PPP encapsulation on an interface
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable PPP encapsulation on
the interface.
link-protocol ppp
By default, all interfaces except
Ethernet interfaces, VLAN
interfaces, and ATM interfaces use
PPP as the link layer protocol.
Configuring PPP authentication
You can configure several authentication modes simultaneously. In LCP negotiation, the authenticator
negotiates with the peer in the sequence of configured authentication modes until the LCP negotiation
succeeds. If the response packet from the peer carries a recommended authentication mode, the
authenticator directly uses the authentication mode if it finds the mode configured.

HP MSR Router Series Specifications

General

Brand	HP
Model	MSR Router Series
Category	Network Router
Language	English