HP MSR Router Series User Manual

82
Step Command Remarks
6. (Optional.) Set the description
for the interface.
description text
By default, the description of an
interface is in the format of
interface-name Interface, for
example, Virtual-PPP254
Interface.
7. Set the MTU size of the
interface.
mtu size The default setting is 1500 bytes.
8. (Optional.) Set the keepalive
interval.
timer-hold seconds The default setting is 10 seconds.
9. (Optional.) Set the keepalive
retry limit.
timer-hold retry retry The default setting is 5.
10. (Optional.) Specify a primary
traffic processing unit for the
interface.
• Distributed devices in
standalone mode/centralized
devices in IRF mode:
service slot slot-number
• Distributed devices in IRF
mode:
service chassis
chassis-number slot
slot-number
By default, no primary traffic
processing unit is specified.
11. (Optional.) Specify a backup
traffic processing unit for the
active card.
• Distributed devices in
standalone mode/centralized
devices in IRF mode:
service standby slot
slot-number
• Distributed devices in IRF
mode:
service standby chassis
chassis-number slot
slot-number
By default, no backup traffic
processing unit is specified.
12. (Optional.) Set the expected
bandwidth for the interface.
bandwidth bandwidth-value
By default, the expected
bandwidth (in kbps) is interface
baudrate divided by 1000.
13. (Optional.) Restore the default
settings for the interface.
default N/A
14. (Optional.) Bring up the
interface.
undo shutdown By default, an interface is up.
Configuring an LNS
An LNS responds to the tunneling requests from an LAC, authenticates users, and assigns IP addresses to
users.
Creating a VT interface
After an L2TP session is established, a virtual access (VA) interface is needed for data exchange with the
peer. The system will dynamically create VA interfaces based on the parameters of the virtual template

HP MSR Router Series Specifications

General

Brand	HP
Model	MSR Router Series
Category	Network Router
Language	English