EasyManua.ls Logo

HP MSR Router Series

HP MSR Router Series
293 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
144
Ste
p
Command
Remarks
6. Configure related
parameters for AIS/RDI
alarm cell detection.
oam ais-rdi up up-seconds down
down-seconds
By default, the PVC goes down
when the system receives successive
AIS/RDI alarm cells in one second.
The PVC comes up when the system
does not receive any AIS/RDI alarm
cells in 3 seconds.
7. Send OAM F5 end-to-end
cells to check the link
connection.
oam ping interface atm
{ interface-number |
interface-number.subnumber } pvc
{ pvc-name | vpi/vci } [ number
timeout ]
Available in any view.
Displaying and maintaining ATM
Execute display commands in any view and reset commands in user view.
Task Command
Display PVC information.
display atm pvc-info [ interface interface-type { interface-number |
interface-number.subnumber } [ pvc { pvc-name | vpi/vci } ] ]
Display PVC-group
information.
display atm pvc-group [ interface interface-type { interface-number |
interface-number.subnumber } [ pvc-group group-number ] ]
Display mapping
information about PVCs
or PVC-groups.
display atm map-info [ interface interface-type { interface-number |
interface-number.subnumber } [ pvc { pvc-name | vpi/vci } | pvc-group
group-number ] ]
Display VE interface
information.
display interface [ virtual-ethernet [ interface-number ] ] [ brief [ description |
down ] ]
Clear PVC statistics.
reset atm interface [ interface-type { interface-number |
interface-number.subnumber } ]
Clear VE interface
statistics.
reset counters interface [ virtual-ethernet [ interface-number |
interface-number.subnumber ] ]
ATM configuration examples
IPoA configuration example
Network requirements
As shown in Figure 46, Router A, B, and C are connected to the ATM network for intercommunication.
The IP addresses of the ATM interfaces of the three routers are 202.38.160.1/24, 202.38.160.2/24, and
202.38.160.3/24.
In the ATM network:
The VPIs/VCIs of Router A are 0/40 and 0/41, connected to Router B and Router C, respectively.
The VPIs/VCs of Router B are 0/50 and 0/51, connected to Router A and Router C, respectively.

Table of Contents

Other manuals for HP MSR Router Series

Related product manuals