HP MSR Router Series User Manual

181
To configure a dialer interface to place calls:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a dialer interface and
enter its view.
interface dialer number N/A
3. Enable bundle DDR on the
interface.
dialer bundle enable
By default, bundle DDR is
disabled.
4. Specify a dial string.
dialer number dial-number N/A
5. Return to system view.
quit N/A
6. Enter physical interface view.
interface interface-type
interface-number
N/A
7. Assign the physical interface
to the specified dialer bundle.
dialer bundle-member number
[ priority priority ]
By default, a physical interface
does not belong to any dialer
bundle.
Make sure the number arguments
in the interface dialer and dialer
bundle-member commands use
the same value.
Configuring a dialer interface to receive calls
To configure a dialer interface to receive calls, you only need to enable DDR on the interface. You do not
need to configure dial strings. At the receiving end, configure PAP or CHAP authentication (see
"Configuring PPP and MP") on the physical interface and the dialer peer-name command on the dialer
interface.
To configure an interface to receive calls:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a dialer interface and
enter its view.
interface dialer number N/A
3. Enable bundle DDR on the
interface.
dialer bundle enable
By default, bundle DDR is
disabled.

HP MSR Router Series Specifications

General

Brand	HP
Model	MSR Router Series
Category	Network Router
Language	English