HP MSR Router Series

47
Ste
p
Command Remarks
6. Enter Layer 3 Ethernet
interface/subinterface, Layer
3 virtual Ethernet
interface/subinterface, Layer
3 aggregate
interface/subinterface,
VE-L3VPN
interface/subinterface, or
EFM interface/subinterface
view.
interface interface-type
interface-number
N/A
7. Enable the PPPoE server on
the interface and bind this
interface to the specified VT
interface.
pppoe-server bind virtual-template
number
By default, the PPPoE server is
disabled on the interface.
8. (Optional.) Configure an
access controller (AC) name
for the PPPoE server.
pppoe-server tag ac-name name
By default, the AC name for the
PPPoE server is the device name.
PPPoE clients can choose a
PPPoE server according to the
AC name. The PPPoE client on
HP devices do not support this
feature.
9. (Optional.) Enable the PPPoE
server to support the
ppp-max-payload tag and
specify a range for the PPP
maximum payload.
pppoe-server tag ppp-max-payload
[ minimum minvalue maximum
maxvalue ]
By default, The PPPoE server
does not support the
ppp-max-payload tag.
10. Configure a service name for
the PPPoE server.
pppoe-server tag service-name name
By default, a PPPoE server does
not have a service name.
11. (Optional.) Set the response
delay time for user access.
pppoe-server access-delay delay-time
By default, no response delay
time is set.
12. Return to system view.
quit N/A
13. Configure the PPPoE server
to perform authentication,
authorization, and
accounting for PPP users.
See Security Configuration Guide. N/A
Setting the maximum number of PPPoE sessions
PPPoE can establish a session when none of the following maximum numbers are reached:
• The maximum number of PPPoE sessions for a user on an interface.
• The maximum number of PPPoE sessions for a VLAN on an interface.
• The maximum number of PPPoE sessions on an interface.
• The maximum number of PPPoE sessions on a card. (Distributed devices.)
• The maximum number of PPPoE sessions on an IRF member device. (Centralized devices in IRF
mode.)
• The maximum number of PPPoE sessions on a device. (Centralized devices in standalone mode.)
New maximum number settings apply only to subsequently established PPPoE sessions.