EasyManuals Logo

HP MSR Router Series User Manual

HP MSR Router Series
293 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #141 background imageLoading...
Page #141 background image
132
• OAM Alarm Indication Signal/Remote Defect Indication—The PVC goes down when specific
number of successive AIS/RDI alarm cells are received. The PVC comes up when no AIS/RDI alarm
cells are received within the specified time.
• OAM Continuity Check—OAM CC requires that one end of the PVC must be configured as the CC
cell source and the other end as the CC cell sink. If the detecting end fails to receive CC cells within
3 seconds, the state of the PVC changes to down. The PVC comes up only after CC cells are
received again.
• OAM F5 Loopback—Sends OAM F5 Loopback cells at the specified interval after you enable OAM
F5 Loopback transmission and retransmission detection and specify related parameters. If the
sender fails to receive a response cell within the specified interval, it sends an OAM F5 Loopback
cell again. The state of the PVC is updated during the Loopback detection. The PVC comes up when
the specified number of successive OAM F5 Loopback cells are received. The PVC goes down when
the specified number of successive OAM F5 Loopback cells are not received.
• OAM F5 end-to-end—Sends OAM F5 end-to-end cells through the specified PVC on the specified
ATM interface. If no response is received within the specified period, the link might be disconnected
or congested.
Compatibility information
This feature is supported only on routers installed with the following modules:
• ADSL2+.
• ATM-OC3.
• G.shdsl.
• G.shdsl.Bis.
ATM configuration task list
Tasks at a
g
lance
Remarks
(Required.) Configuring an ATM interface N/A
(Required.) Configuring a PVC N/A
(Optional.) Configuring a PVC-group
N/A
(Required.) Configuring the ATM AAL5 encapsulation type
N/A
(Required.) Configuring the ATM service type N/A
Configuring applications carried by ATM
:
• (Optional.) Configuring a VE interface
• (Required.) Perform one of the following tasks:
{ Configuring IPoA
{ Configuring IPoEoA
{ Configuring PPPoA
{ Configuring PPPoEoA
When you configure IPoEoA or
PPPoEoA, you must configure VE
interfaces.
(Optional.) Configuring VP policing
N/A
(Optional.) Re-marking the CLP flag value of ATM cells
N/A

Table of Contents

Other manuals for HP MSR Router Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP MSR Router Series and is the answer not in the manual?

HP MSR Router Series Specifications

General IconGeneral
BrandHP
ModelMSR Router Series
CategoryNetwork Router
LanguageEnglish

Related product manuals